American International Electric SEG-M Connection the SEG-1 to a HubMax or Hub MiniMax RS-232

3.2Connection the SEG-1 to a HubMax or Hub MiniMax (RS-232)

Two different methods can be used to connect Port A of the HubMax or HubMiniMax to the SEG-1:

1.Connect to the RS232 modular jack (front of SEG-1)

2.Connect to the RS232 terminals (rear of SEG-1)

NOTE: If connection to SEG-1 is NOT located at the HubMax or HubMiniMax then the connection must be made via stranded/shielded cable.

3.2.1SEG-1 to HubMax/Hub MiniMax Connection Method 1

The diagram below illustrates the method to connect the HubMax or HubMinimax to the RS232 port of the SEG-1 via its RS232 modular jack on the front of the unit.

3.2.2SEG-1 to HubMax/Hub MiniMax Connection Method 2

The diagram below illustrates the method to connect the HubMax or HubMinimax to the RS232 port of the SEG-1via the terminal block at the rear of the unit.

NOTE: The stranded shielded cable used in the diagram shows the connection to the SEG-1 across a distance.

*THIS CHART PERTAINS TO THE CABLE RUN BETWEEN THE SEG-1 AND IEI ACCESS SYSTEMS

Document Number: 6066005, Rev 3.2 Page 5 of 34