Pioneer PDP 427CMX technical manual When removing the Plasma Display

Wall Mount Unit: PDK-WM01 [507CMX : 427CMX]

8With the lock bar in the lock position, fix the lock plate firmly in place with push rivet and the anchor screw (M6 x 14 mm (9/16 inch)) (one location: left and right sides) removed in step 1 (one location: left and right sides).

•If there are speakers installed on both sides

Fix in place with the anchor screw (M6 x 14 mm (9/ 16 inch)) removed in step 1 (*1).

Unlocked Locked position position

Lock bar in the lock position.

Anchor screw (*1)

4.7.4 When removing the Plasma Display

Before beginning this procedure, turn off the power to the Plasma Display and peripheral

Caution devices. Remove the power plugs from the outlets. Also remove connecting cables if necessary.

1Loosening the screw on the tilt adjustment metal fitting.

Note

Removing the Plasma Display without removing the tilt adjustment metal fitting (may scratch the wall).

2Remove the push rivet and anchor screws that are holding the lock plate. Then, remove the anchor screws that are holding the PDP metal fitting (two locations on the left and right).

	Push rivet
Anchor screw	Anchor screw
Lock plate

3Unlock the lock bar (two locations on the left and right).

Lock bar

Unlocked Locked position position

Set the lock bar in its unlocked position

114