Pioneer PDP 427CMX technical manual FRC Setting, Changes the frame rate

Integrator Mode

19) FRC Setting

This option allows switching of the frame rate conversion.

Factory setting: ON

1Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 214).)

2Select ‘OPTION’.

3Place the cursor on ‘FRC’ then press the [SET] button. Each time the [SET] button is pressed, the setting changes

as shown below.

3ON OFF 2

ON	Changes the frame rate.
OFF	Does not change the frame rate.

The ‘FRC’ setting is common for all inputs.

Screen 3

I N T E G R AT O R				I N P U T 1
PICTURE S C R E E N		S E T U P		O P T I O N
F A N C O N T R O L		: A U T O
O S D	I N D I C ATO R :
F R O N T			O N
C O L O R MOD E		: N O R M A L
P R O U S E
F R C		:	O N
SET CHANGE			MENU	EXIT

FRC

MODE

Use

Input correspondence signals

PC	Vertical frequency	Horizontal frequency	Remarks
	Fv (Hz)	Fh (kHz)

OFF

			49.67	24.69	640 x 480
Retake at a TV studio	PC		49.54	24.62	848 x 480
(PAL camera)	50Hz		50.08	40.365	1024 x 768
			49.861	39.988	1280 x 768
			59.94	31.47	640 x 480
			60.00	31.02	848 x 480
Retake at a TV studio	PC		60.00	48.36	1024 x 768
(NTSC camera)	60Hz		59.87	47.78	1280 x 768
			60.02	63.98	1280 x 1024
			60.00	65.32	1400 x 1050
FILM re-shoot for a movie	PC	*1	48.003	38.69	1024 x 768
(48 Hz camera)	48Hz	*2	48.014	38.51	1280 x 768

*1, 2: The recommended signal formats are shown below.

	Dot Clock	H-Period	H-Sync	H-BP	H-Disp	H-sync	V-Period	V-Sync	V-BP	V-Disp	V-sync
						polarity					polarity
*1	52MHz	1344dot	134dot	163dot	1024dot	nega	806line	4line	31line	768line	nega
*2	65MHz	1688dot	118dot	242dot	1280dot	nega	802line	4line	29line	768line	nega

242