Pioneer PDP 427CMX technical manual Stabilizing on the floor Using a wall for stabilization

Table Top Stand: PDK-TS07 [507CMX : 427CMX]

After attachment, take measures to prevent it from falling over.

7 Stabilizing on the floor 7 Using a wall for stabilization

Stabilize the equipment as shown in the diagram using screws that are available on the market.

1Attaching the accessory falling prevention bolts (hooks) to the Plasma Display (two locations).

Note

To stabilize the equipment on the floor, use screws that have a nominal diameter of 6 mm (1/4 inch) and that are at least 20 mm (13/16 inch) long.

15 mm	5/8 inch)
9 mm to	(3/8 inch to

6 mm

Min. 20 mm (13/16 inch)

(1/4 inch)

2Using strong cords to firmly stabilize it appropriately and firmly to a wall, pillar, or other sturdy element.

Perform this work in the same way on the left and right sides.

Note

Use cords and fittings (eye screw) that are available on the market.

1Falling prevention bolts

2Cords

Fittings (eye screw)

102