Pioneer PDP 427CMX technical manual Speaker System PDP-S56-LR 427CMX, 142

Speaker System: PDP-S56-LR [427CMX]

4.12.3Installation on the Plasma Display

1)Installation procedure

Install the speaker system according to the steps (1) through (4).

Notes

•The speakers are designed specifically for the left

(L) and right (R) sides of the Plasma Display. When mounting them on the display, refer to the letters (“L” and “R”) indicated on the speakers’ hooks.

•This speaker is of an antimagnetic design; however, depending on its placement such as bringing the speaker into the vicinity of a monitor other than a Plasma Display, the speaker may cause irregular noise or other effects. Should this occur, please move the speaker away from the monitor.

(1)Remove the seals from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below.

Cushions

(2)Screw the M8 screws loosely into the screw holes located at the top of the Plasma Display (two locations).

Screws (M8)

142

(3)Fit the hooks at the top of the speakers over the screws just inserted, then align the holes in the hooks of the speakers over the screw holes at the bottom of the Plasma Display and use the M8 screws to screw loosely into place.

Screws (M8)

(4)Tighten the screws just inserted firmly into place (four locations).

*Tighten the screws while pushing the speakers lightly against the Plasma Display. Check to be sure that all four screws have been screwed firmly into place.

Warning

Never hold the speakers when speakers are attached to the monitor to move the monitor. Doing so might result in the monitor falling, and this in turn might result in bodily injury.