Pioneer PDP 427CMX Video Wall Setting, Position Type Normal Auto ID OFF On Delay ABL Link

Integrator Mode

11) VIDEO WALL Setting

Use this feature to configure a four panel to 25-panel video wall.

Note

This setting is adjusted when the screen size is full display.

It is not correctly displayed in other screen sizes. (See pg. 161)

Factory setting: DIVIDER	OFF
POSITION	–
TYPE	NORMAL
AUTO ID	OFF
P.ON DELAY	OFF
ABL LINK	OFF

[Setting Method]

7Setting the ID NO. SET

Refer to “13) Assigning an ID“ (pg. 233)

7Setting the screen divider

1Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 214).)

2 Select ‘OPTION’.
3 Place the cursor on ‘VIDEO WALL’ then press the [SET]	Screen 3
button.
		I N T E G R AT O R					I N P U T 1
		P I C T U R E			S C R E E N	S E T U P		O P T I O N
		P ROG R A M T I M E R
		S C R E E N M A S K				: G R E E N
		S I D E	M A S K
		V I D E O		WA L L
		BAU D	R A T E			: 3 8 4 0 0 B P S
		I D N O . S E T				: 0 1 H

SET

ENTER

MENU

EXIT

4Place the cursor on ‘DIVIDER’.

5Press the [2/3] buttons then press the [SET] button to change the settings.

Each time the [2/3] buttons are pressed, the setting changes as shown below.

	3OFF 3		31 3		3 2x2 3	3 3x3 3
			3 5x5	3	3 4x4	3
OFF, 1	.....	Screen division is not performed. Set it to ‘1‘
		to set an ABL link without dividing the screen.
2x2		Four panel video wall
3x3		Nine panel video wall
4x4		16-panel video wall
5x5		25-panel video wall

Note

Screen 4, 5

V I D E O WA L L

D I V I D E R	: O F F
P O S I T I ON	: N O R M A L
T Y P E
AU TO I D	: O F F
P . O N D E L AY
A B L L I N K	: O F F
R E T U R N
SET	MENU EXIT

•When four to 25 screens have been selected, set POSITION.

•When a problem occurs while programming the video wall settings, externally power down the video wall panels.

228