Pioneer PDP 427CMX technical manual Setting the ABL Link

Integrator Mode

(When 16 and 25 screen Video Walls)

3OFF 2

2

MODE2 2

2

MODE1 2

OFF → MODE1 (after approx. one second)* → MODE2 (after approx. two seconds)* * The seconds shown above are yardstick targets; errors may occur.

Shift and set the power on timing by grouping OFF, MODE1, and MODE2.

7Setting the ABL LINK

This option synchronizes the screen brightness on the multiple displays that form a Video Wall. Apply the AUTO ID function the select a screen divider option (other than OFF).

~Place the cursor on ‘ABL LINK’ then press the [2/3] buttons to change the settings.

Each time a [2/3] button is pressed, the setting changes as shown below.

3ON 2

3 OFF 2

[Setting the ABL LINK]

ON	Brightness of each screen on the video wall is
	the same (available for four panel and nine
	panel video walls only).
OFF	Brightness of the screens depends on the
	setting of each display.

[Connecting four displays]

When this option is ‘ON’, connect the four displays according to the POSITION sequence numbers in the figure on the right with the combination cable (Mini-DIN, 6 pin). If the screen division or POSITION has changed, the ABL link automatically turns off.

Screen ~

V I D E O WA L L

D I V I D E R		: O F F
P O S I T I ON
T Y P E		: N O R M A L
AU TO I D
P . O N D E L AY		: O F F
A B L L I N K		:	O F F
	R E T U R N
			MENU EXIT
	SET

				COMBINATION
COMBINATION		No.1	No.2	OUT		No.1	No.2	COMBINATION
IN		No.4	No.3	COMBINATION		No.4	No.3	OUT
				IN
	Display 1				Display 2
				COMBINATION
COMBINATION		No.1	No.2	OUT		No.1	No.2	COMBINATION
OUT		No.4	No.3			No.4	No.3
				COMBINATION				IN
	Display 3			IN
					Display 4

Note

•Connect in the same way for a nine panel video wall.

•In case of a 16 or 25 panel video wall, it is recommended that it be used with the power saving setting for the entire screen changed to MODE1.

The ‘VIDEO WALL’ settings are common for all inputs.

231