Pioneer PDP 427CMX technical manual Color Decoding Setting, INPUT1, INPUT2, INPUT5, Connected

[Applicable only when a PDA-5003/PDA-5004 is installed] Menu Mode

7)Color Decoding Setting

When a video signal is input at INPUT1, INPUT2 and INPUT5, it corresponds to an RGB and component video signal. This setting must comply with the connected device.

The setting should be performed as shown below for INPUT1, INPUT2, and INPUT5. (Example)

•When reproducing an RGB signal: Set to ‘COLOR DECODING: RGB’.

•For reproduction from a DVD player: Set to ‘COLOR DECODING: COMPONENT1’.

Settable condition:	INPUT1, INPUT2, INPUT5
	When a video signal (signal other than a PC signal) is input
Factory setting:	For 525i, 525p, 625i, 625p signal input: COMPONENT1
	For 750p, 1125i, 1125p, 1250p signal input: COMPONENT2
1 Select ‘SETUP’.

2Place the cursor over ‘COLOR DECODING’ then press the [SET] button to change the setting.

Each time the [SET] button is pressed, the setting changes as shown below.

3RGB 3 COMPONENT1 COMPONENT22

Set ‘COLOR DECODING‘ as follows.

Please take care when assigning settings. Incorrect settings can adversely affect the Plasma Display.

SETUP
Connected	COLOR DECODING
component
Component video output of	COMP.1
Y/Cb/Cr format.
For example, DVD player, etc.
Component video output of	COMP.2
Y/Pb/Pr format.
For example, digital tuner, etc.
RGB video output of a video deck	RGB
etc., with RGB output
DVI video output of an AV	RGB
component with DVI output port
RGB video output of a PC	Not supported

Screen 2

M E N U				I N P U T 1
PICTURE S C R E E N			S E T U P	O P T I O N
C O L O R T E M P.			: M I D D L E
A U T O P O W E R O F F			: D I S A B L E
D N R			: M I D D L E
M P E G N R			: L O W
C T I			: O N
P U R E C I N E M A			: O F F
C O L O R D E C O D I N G			: R G B
C O L O R S Y S T E M			: A U T O
S I G N A L F O R M AT
	SET	CHANGE	MENU EXIT

197