Pioneer PDP 427CMX technical manual 106

Tilt Mount Unit: PDK-5011 [507CMX : 427CMX]

4.6.3 Assembling the mounting hardware and mounting the Plasma Display

1Remove the special screws (two locations) from the bottom of the wall mounting unit.

Special screws (M6)

2Remove the hardware on the wall side half and the hardware on the PDP side half.

Wall side hardware

PDP side hardware

3Attach the PDP side hardware to the Plasma Display.

Note

•Place a sheet or protective cover to protect the display from scratches or damage.

•Be sure to attach it on top of a flat table or similar surface.

PDP side hardware

Top side of Plasma Display

106

4Fix the Plasma Display to the PDP side hardware with M8 bolts (six locations).

Use the holes marked with the red triangle "%".

Top side of Plasma Display

Note

Be sure to install speakers at this stage.

For the installation method, refer to the speaker instruction manual.

5Attach the wall side hardware to the wall.

Install the wall side hardware (four locations) symmetri- cally on the left and right side (one at each location

from the center of the ). Wall strength and ma- terial determines the type of screws and bolts (sold separately) needed for this installation.

Note

Check the strength of the wall and beams before in- stalling the display.