Pioneer PDP 427CMX Normal Operating Mode Normal Operation Mode, About normal operation mode

Normal Operating Mode

5.2 Normal Operation Mode

5.2.1 About normal operation mode

The following controls are possible in the normal operation mode.

1Switching input

•Pressing the [INPUT1] to [INPUT5] buttons on the remote control changes the input that setting.

•Pressing the [INPUT] button on the main-control panel changes the input each time the button is pressed.

Note

When a PDA-5003 or a PDA-5004 is not installed, the input switches only between INPUT1 and INPUT2.

2Switching the screen size

•Each time the [SCREEN SIZE] button on the remote control or main-control panel is pressed, the display screen size changes.

When reproducing a PC signal

3DOT BY DOT FULL

3 4: 3

3

When reproducing a video signal (signal other than a PC signal) ★ (Applicable only when a PDA-5003 or a PDA- 5004 is installed.)

3 4:3		3 FULL	3 WIDE
	14:9 2	2.35:1 2	ZOOM 2

Note

•The reproducible screen size changes according to the input signal.

Refer to the section 5.1.3, “List of Input Correspondence Signals” (pg. 146).

•To select ‘Underscan’, set the PRO USE option in the integrator mode.

When this display is to be used for commercial use or for public viewing, such as in a coffee shop or hotel, reducing or enlarging the screen by using the screen-size-switching function could infringe on the copyright of the creator according to copyright laws.

2Display call

A Pressing the [DISPLAY] button on the remote control or main-control panel displays the current input function, horizontal and vertical frequency of the input signal, the type of signal, and the screen size (DISPLAY CALL 1).

Note

The displayed horizontal and vertical frequencies are measured values. Measurement errors are possible.

B Pressing the [DISPLAY] button on the remote control or main-control panel again for three seconds or more when the display described in A above is displayed, cause various settings and internal temperature to be displayed as shown below (DISPLAY CALL 2).

P D P - 5 0 7 C M X
S E R I A L N O .	: * * * * * * * * * * * * * * * *
L OT	: 0 0 1 A 0 0 1 K
DAT E	: 0 0 1 A 0 0 1 X
H O U R M E T E R	: 0 0 2 3 9 H
T E M P E R AT U R E	: + 2 5
O S D	: O N
BAU D R AT E	: 9 6 0 0 B P S
FA N C O N T R O L	: AU TO
I D N O . S E T	: A L L
C O L O R M O D E	: N O R M A L
I N F O R M AT I O N
: A B C D E F G H I J K L M N

SERIAL NO.: Displays the serial number of the product

LOT/DATE: Displays the manufacturing control number

HOUR METER: Displays the conduction time for the product

TEMPERATURE: Displays the outside air temperature that is measured by a temperature sensor located in the product

Other items: Displays the settings in the integrator mode

* Illustration depicts PDP-507CMX model.

Note

When the displayed temperature is high, the panel shuts down. However, the display itself should always be used as an indicator.

171