Pioneer PDP 427CMX technical manual Display Rotate the screw to adjust the tilt

[507CMX : 427CMX] Wall Mount Unit: PDK-WM01

5Install the wall side metal fitting to the wall

Fix it firmly in place symmetrically to the left and right (four or more locations).

Wall strength and material determines the type of screws and bolts (sold separately) needed for this installation.

Note

Chack the strength of the wall, columns, etc. before beginning the installation.

6Hang the hook of the PDP side metal fitting on the wall side metal fitting

1 Hang the hook on the ceiling surface part of the

PDP side metal fitting on the wall side metal fitting.

2Raise the lock bar to attach the Plasma Display. Make sure that the lock bar is fully lowered.

Hook of the PDP side metal fitting

21

Hang the hook.

Lift the lock bar to its unlocked position.

￿ Always have at least two people do this task.

￿ Check that the hook has been hung before

Caution lifting the Plasma Display.

Note

￿If speakers are attached, do not hold the speakers to perform this attachment.

￿Be careful that the wiring etc. is not caught in the metal fitting or on the Plasma Display. When a speaker is attached, the wiring is easily caught between the wall and the speaker.

7Fine adjustment of the left-right tilt of the Plasma Display.

If the Plasma Display is slightly tilted to the left or right after it is installed on the wall, adjust this tilt by attaching the adjustment metal fitting (at lone location on the right and on the left).

Insert the tilt adjustment metal fitting in the notch on the top surface of the PDP side metal fitting that is tilted downward. Attach it by rotating the screw.

1 Rotate the screw until the gap between the wall side metal fitting and the tilt adjustment metal fitting disappears. When the gap between the wall side metal fitting and the tilt adjustment metal fitting has disappeared, the screw becomes difficult to rotate and begins to lift up the Plasma

Display.

2Rotate the screw to adjust the tilt.

Tilt adjustment	Screw head
metal fitting
	Gap
	Tilt adjustment
	metal fitting

Note

The range that the tilt can be adjusted by the screw is about 5 mm (3/16 inch). The screw rotates about three times. Be careful not to over-rotate the screw. If the screw is turned too much, the metal fitting may be damaged.

113