Pioneer PDP 427CMX technical manual Assembling the mounting hardware Mounting the display

Wall Mount Unit: PDK-WM01 [507CMX : 427CMX]

4.7.3 Assembling the mounting hardware and 3

mounting the display

1Remove the push rivet of the lock plate and the bottom anchor screw (M6 x 14 mm (9/16 inch)) (one location: left and right sides)

1Move the push rivet of the lock plate to its unlocked position (shown in the figure below).

2Remove the anchor screw from the bottom.

		Pull the
		push
		rivet
	Locked	Unlocked
	position	position
		4
Lock plate	Push rivet
Anchor screw (M6 x 14mm)

Note

Be careful not to lose the two anchor screws (M6 x 14 mm (9/16 inch)) because they will be used later.

2Release the lock bar (one location: left and right sides)

Lock bar

Unlocked Locked position position

	Set the lock bar in the
Lock bar	unlocked position.

Remove the PDP side metal fitting

1Lift the lock bar to the position where the lock on

the PDP side metal fitting is released.

2While holding the lock bar up, pull out the bottom

of the PDP side metal fitting.

3Lift then remove the PDP side metal fitting.

	3
1	Lock bar
PDP side metal fitting
2
	1
	Wall side metal fitting

Attach the PDP side metal fitting to the Plasma Display

1Spread a sheet or similar material so that the

display will not be scratched or damaged.

2Fix the PDP side metal fitting firmly to the Plasma Display with M8 bolts (six locations).

Bolts M8

PDP side

metal fitting

Top side of the

Plasma Display

Note

￿Always install it on top of a stable table or similar surface.

￿If you plan to install speakers and cables, please install them at this stage.

Do not connect cables for any other device.

￿For the speaker installation method, refer to the speaker installation procedure in the Plasma Display operating instructions.

112