Pioneer PDP 427CMX Purecinema Setting, Off, Conversion is performed without, I/P is converted

[Applicable only when a PDA-5003/PDA-5004 is installed] Menu Mode

6)PURECINEMA Setting

The PURECINEMA function automatically detects video signals such as movies that are filmed at 24 frames per second then converts them to a progressive video signal by a 2-3 pull-down process. Normally, when the PURECINEMA function is used, the ‘ON’ setting should be used.

The PURECINEMA setting should be performed for each input (INPUT1 to INPUT5) and each signal.

Settable condition: When there is video signal input

Factory setting: ON

1 Select ‘SETUP’.
2 Place the cursor over ‘PURECINEMA’ then press the [SET]	Screen 2
button.
	M E N U		I N P U T 1
	P I C T U R E S C R E E N	S E T U P	O P T I O N
	C O L O R T E M P.	: M I D D L E
	A U T O P O W E R O F F	: D I S A B L E
	D N R	: M I D D L E
	M P E G N R	: L O W
	C T I	: O N
	P U R E C I N E M A	: O F F
	C O L O R D E C O D I N G	: R G B
	C O L O R S Y S T E M	: A U T O
	S I G N A L F O R M AT
	SET ENTER	MENU EXIT

3Each time a [2/3] button is pressed, the setting changes as shown below.

3 OFF 2

	3 ON 2
• OFF	..................	I/P conversion is performed without
		detecting the signal of the film source
• ON		The film source signal is detected then
		the I/P is converted
Note

Screen 3

P U R E C I N E M A			:		O F F
	SET	SET		MENU	EXIT

The modes that can be selected differ. Specific information is available on the next page.

195