Pioneer PDP 427CMX technical manual Screen Position, Clock Frequency and Clock Phase Adjustment

Menu Mode

10) Screen Position, Clock Frequency and Clock Phase Adjustment

In AUTO SET UP, the position and clock are optimally set. However, depending on the type of signal, adjustment may be off. If this should occur, refer to the procedure below and make the adjustment manually.

Example) When a PC signal is input to INPUT1 (1024 x 768)

1Set the screen size to ‘DOT BY DOT’.

2Select ‘SCREEN’.

3Place the cursor on ‘POSITION’ then press the [SET] button.

Screen 2

M E N U			I N P U T 1
PICTURE S C R E E N	S E T U P		O P T I O N
P O S I T I O N	:	0/ 0
C L O C K	:	0
P H A S E	:	0

S C R E E N R E S E T

SET ENTER

MENU EXIT

4Use the [5/∞] and [2/3] buttons to adjust the screen position.

Here, the top and left side of the video display are properly set.

1.With the [∞] button, lower the display until the mask (black portion) protrudes into the top of the image.

2.With the [5] button, move the display to the point where the mask at the top disappears.

3.With the [3] button, move the display until the mask (black portion) protrudes into the left side of the image.

4.With the [2] button, move the display to the point where the mask on the left side disappears.

5Place the cursor on ‘CLOCK’ then press the [SET] button.

Screen 4

			P O S I T I O N
		H	V
+ 8 8			+ 8 8
		SET	MENU EXIT
	SET

Screen 5

MENU			INPUT1
PICTURE SCREEN	SETUP		OPTION
P O S I T I O N	:	0/ 0
C L O C K		0
P H A S E	:	0

S C R E E N R E S E T

SET ENTER

MENU EXIT

184