Pioneer PDP 427CMX technical manual 126

Mobile Cart: PDK-5014 [507CMX : 427CMX]

2Attach bracket bolts to display stand

Attach the hexagonal bored bolts (M8 ⋅ 20 mm) to the display stand, being sure to leave a space of 5 to 6 millimeters when doing so. These bolts may be attached at two different levels to allow a distance of 1350 mm or 1170 mm from the floor to the center of the display panel.

Note

Do not place bracket bolts in the third set of screw holes from the top. These screw holes are used in Step 4 below.

Display stand

Hexagonal bored bolts (M8 ⋅ 20 mm)

5 mm to 6 mm

3Attach bracket to Plasma Display

Using the hexagonal bored bolts (M8 ⋅ 20 mm), attach the bracket to the rear of the Plasma Display by screwing the bolts into the screw holes as the figure.

Note

•The Plasma Display should be placed on a blanket or other soft surface to avoid scratching or otherwise damaging the surface of the display.

•For safety, alternately tighten each bolt two times or more until they are firmly fixed in place.

Hexagonal bored bolts (M8 ⋅ 20 mm)

Bracket

Top side of Plasma Display

Plasma Display

126