Pioneer PDP 427CMX Cabinet and Remote-control Unit, Disconnect and Remove Hardware

Maintenance

1) Be sure to unplug the power cord from the power outlet before performing maintenance.

Note

If the plasma display is connected to a computer linked to a network, disconnect and reconnect using the following procedure.

7Disconnect and Remove Hardware

1Turn the plasma display to Standby using either the computer (RS-232C control) or the remote control.

2Turn off the power to the computer.

3Turn off the main power to the plasma display.

4Remove the RS-232C cable and RGB cable from the plasma display.

5Remove the RS-232C cable and RGB cable from the computer.

6Remove the power cord from the computer.

7Remove the power cord from the plasma display.

8Finally remove hardware.

7Connection procedure

1Connect the power cord of the plasma display to an AC power source.

2Connect the power cord of the computer to an AC power source.

3Connect the RS-232C cable and RGB cable to the computer.

4Connect the RS-232C cable and RGB cable to the plasma display.

5Turn on the power to the computer.

6Turn on the main power to the plasma display.

7Turn on the plasma display using either the computer (RS-232C control) or the remote control.

Note

After disconnection, wait for approximately 10 minutes before reconnecting the units.

2)Cabinet and Remote-control Unit

Never use solvents such as benzene or thinner. Using such solvents could cause the cabinet and remote control to degrade the coating.

Wipe the cabinet and remote control with a soft cloth. If there is heavy soiling, soak a soft cloth in water mixed with a mild detergent. Ring out the water well then clean the panel. Dry the chassis by wiping with a soft, dry cloth.

287