American Megatrends MAN-758 manual J4 Floppy, Connect I/O, Continued

Step 10 Connect I/O, Continued

J4 Floppy	J4 is a 34-pin dual-inline berg. Connect the cable from the floppy drive to J4, as
	shown below. The onboard floppy controller cannot be used if a hard disk card
	with a floppy controller is installed. Choose Standard Setup and Peripheral
	Setup to configure the floppy controller.

The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½" drives and 360 KB and 1.2 MB 5¼" drives. The connecting cable is a 34-pin ribbon connector with two 34-pin edge connectors for attaching the floppy disk drives. There is a small twist in the cable between the floppy connectors. The last (end) connector should be connected to floppy drive A :.

Cont’d

Chapter 1 Hardware Installation 29