American Power Conversion and S15BLK, S10, S10BLK, S15

1-6

STATUS

Push Button

When pressed, provides unit status for:

Input

and

Output Voltage,

Input

and

Output Frequency

Telephone

and

Internet

contact

information,

Model

and

Serial Number

Firmware

(FW) Version

number,

Source

(

Standby

Battery

, or

Utility

) and

Estimated

Runtime

(in hours or minutes),

Estimated

Runtime

(in hours)

with a

Fuel

(as a percentage with bar graph) indication, as well as

System Load

(in watts), and

Load

(as a percentage with bar

graph).

This push button can also be used to set a default screen, a screen

that is displayed all the time.

Vacuum Fluorescent Display (VFD)*

Conveys information about unit and power status. It is also used to

display information when making settings changes to the unit.

*Note

- The VFD and Light Emitting Diodes (LEDs) can be

dimmed or turned off independently of each other via the front

control panel

SETUP

push button.

Up Arrow Push Button

This button is used to change parameters (increase or turn on) for

various user-selectable settings such as:

Audible Alarms,

Sensitivity, Display Dimmer, LED Dimmer, Go To Bat If,

Outlet 1 & 2 Delay

(in

seconds),

Low Bat Warning, Bat Rep

Date, etc.

LOW BATTERY

Status Indicator

When lit (orange) indicates the Battery Pack charge level is low.

When this indicator turns on, the user can set the value (from

minutes) to allow time to shut off power before the Battery Pack

is fully discharged. When lit, leave the unit plugged in to allow

batteries to recharge. The unit does not have to be powered on for

batteries to recharge.