1-7
LINE OK
Status Indicator
When lit, input voltage from the utility is within acceptable range.
If not lit, the Automatic Voltage Regulation circuit is correcting
high or low voltage levels to maintain safe voltage conditions for
connected components, or the unit is operating on battery power
due to a blackout or extreme voltage level conditions.
FILTERING
Status Indicator
When lit, notifies the user that the Electromagnetic
Interference/Radio Frequency Interference (EMI/RFI) noise
reduction circuit is active.
OVERLOAD
Status Indicator
When lit (red) the unit is overloaded; unplug equipment connected
to the unit until the indicator is no longer lit.
Down Arrow Push Button
Is used to change parameters (decrease or turn off) for various
user-selectable settings such as:
Audible Alarms, Sensitivity,
Display Dimmer, LED Dimmer, Go To Bat If, Outlet 1 & 2
Delay
(in seconds),
Low Bat Warning, Bat Rep Date
, etc.
On/Off Switch
Controls power to all 12 outlets. APC recommends the unit be left
‘on’ at all times. Control power to your system and components
using their own controls as you normally would.
SETUP
Push Button
This push button is used to advance the display through the various
user-selectable set up functions provided by the unit such as:
Audible Alarms
,
Sensitivity
,
Display Dimmer
,
LED Dimmer
,
Go To Bat If
,
Outlet 1 & 2 Delay
(in seconds),
Low Bat Warning
,
Bat Rep Date
, etc.
REGULATING
Status Indicator
When lit (blue), indicates Automatic Voltage Regulation (AVR) is
engaged to correct low or high voltage conditions.
7
8
9
10
11
12
13