2-11
displayed. APC recommends you set the “default” screen showing the
“
ESTIMATED RUNTIME
and
FUEL
” display (Figure 16).
Informational Screens
The S10 and S15 Power Conditioners with Battery Backup provide the following
informational screens, accessed using the
STATUS
push button:
• Source: XXXXXXX screen
• FW Version: XXXXXXX screen
• Model Number and Serial Number screen
• Phone Number and Technical Support Internet Address screen
• Input Frequency; Output Frequency screen
SOURCE: XXXXXXX; EST. RUNTIME: XHRS
Screen
This screen, shown in Figure 17, shows which source the unit is providing power
from (
UTILITY
,
BATTERY
, or
STANDBY
). It also displays the
Estimated
Runtime
(in hours) based on the power source and connected equipment load. In
Standby
mode, the unit does not provide an output to the rear panel outlets.
Note:Whenever the S10 or S15 is connected to utility power, the electronics
inside of each unit are active. If the front panel Power Switch is turned
off, the unit goes into Standby mode and shuts off power to the rear-panel
outlets, but the display remain active.
Figure 17. SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen