American Standard installation instructions MOMENTST506.740, Recommended Tools

Installation

Instructions

MOMENTST506.740

CENTRAL THERMOSTAT

WITH VOLUME CONTROL

TRIM KIT

Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M

ASSE 1016

M 9 6 8 0 2 6

ROUGHING-IN DIMENSIONS

220mm

(8-5/8)

R520

1/2" NPT INLETS

or

R540

3/4" NPT INLETS

170mm

(6-3/4)

186mm

(7-3/8)

NOTE: FITTING	25mm
	(1)
MUST BE INSTALLED
WITH VOLUME CONTROL
ON TOP.

160mm

(6-1/4)

FINISHED

WALL

100mm

(3-7/8)

48mm to 68mm

(2 to 2-5/8)

Recommended Tools

Flat Blade Screwdriver Phillips Screwdriver

CARE INSTRUCTIONS:

To keep your new faucet looking new, please follow these simple care instructions:

DO: Simply rinse the faucet clean with clear water. Dry the faucet with a soft cotton cloth.

DO NOT:

Do not use any abrasive cleaners, cloths, or paper towels.

Do not use any cleaning agents containing acids, polish abrasives, or harsh cleaners or soaps.

Regular and routine cleaning will reduce the need for heavy cleaning and polishing. If heavy cleaning is required, the following procedures are recommended:

Remove as much surface dirt and film using clear water and soft cotton cloth (as described above).

Use any of the following to remove tough surface film and build-up:

Mild liquid detergents

Clear ammonia free liquid glass cleaners Non-acidic, non-abrasive gentle liquid or fully dissolved powder cleansers mixed according to manufacturers directions.

Non-abrasive liquid polishers

Once clean, rinse faucet again with clear water to thoroughly remove cleaner or polish and blot dry with a soft cotton cloth.

Failure to follow these care instructions may damage the Faucet's finish.