American Water Heater 71681, ADCG, DCG3-Series Installation Instructions, Consumer Information

Index

INSTALLATION INSTRUCTIONS

Consumer Information

This water heater is design-certified by CSA International as a Category I, non-direct vented water heater which takes its combustion air either from the installation area or from air ducted to the unit from the outside.

This water heater must be installed according to all local and state codes, or in the absence of local and state codes, with the “National Fuel Gas Code”, ANSI Z223.1(NFPA 54)- latest edition. Canadian installations must be performed in accordance with CAN/ CSA-B149.1. This is available from the following:

American Gas Association

1515 Wilson Boulevard

Arlington, VA 22209

National Fire Protection Agency

1 Batterymarch Park

Quincy, MA 02269

Canadian Standards Association

5060 Spectrum Way

Mississauga, ON

L4W 5N6

Check the phone listings for the local authorities having jurisdiction over this installation.

Installer and Owner Responsibilities

This manual has been prepared to acquaint you with the installation, operation and maintenance of this gas water heater and provide important safety information in these areas.

Read all of the instructions thoroughly before attempting the installation or operation of this water heater. Keep this manual for future reference.

Do not discard this manual. You or future users of this water heater will need it for future reference.

The manufacturer and seller of this water heater will not be liable for any damages, injuries or deaths caused by failure to comply with the installation and operating instructions outlined in this manual.

The manufacturer of this water heater recommends that it be professionally installed by qualified service technicians. Examples of qualified service technicians include: those trained in the plumbing and heating industry, local gas utility personnel or an authorized service person.

Massachusetts code requires this water heater to be installed in accordance with Massachusetts Plumbing and Fuel Gas Code 248 CMR Sections 2.00 and 5.00.

A data plate identifying this water heater can be found on the front of the water heater. When referring to this water heater always have the information listed on the data plate readily available.

Retain your original receipt as proof of purchase.

Unpacking the Water Heater

Excessive Weight Hazard Use two or more people to move and install water heater unless proper handling equipment is utilized. Failure to do so can result in back or other injury.

Removing Packaging Materials

Important: Do not remove any permanent instructions, labels, or the data label from outside of the water heater or on the inside of panels.

•Remove exterior packaging and place installation components aside.

•Inspect all parts for damage prior to installation and start-up.

•Completely read all instructions before attempting to assemble and install this product.

•After installation, dispose of packaging material in the proper manner.

3