Installation Instructions
1
INSTALLING THE WATER LINE (CONT.)
4FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water pipe with the pipe clamp.
Pipe Clamp
|
|
| Vertical Cold | |
|
| |||
Shutoff Valve |
| Water Pipe | ||
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves
7CONNECT THE TUBING TO THE VALVE
Place the compression nut and ferrule (sleeve) for copper tubing onto the end of the tubing and connect it to the shutoff valve.
Make sure the tubing is fully inserted into the valve. Tighten the compression nut securely.
For plastic tubing from an approved refrigerator tubing kit, insert the molded end of the tubing into the shutoff valve and tighten compression nut until it is hand tight, then tighten one additional turn with a wrench. Overtightening may cause leaks.
are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.
5TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing washer begins to swell.
Packing Nut 
Compression
Nut
Approved
Plastic Tubing
NOTE: Do not overtighten or you may crush the tubing.
| Washer |
Pipe Clamp | Inlet End |
Clamp Screw
6ROUTE THE TUBING
Route the tubing between the cold water line and the refrigerator.
Route the tubing through a hole drilled in the wall or floor (behind the refrigerator or adjacent base cabinet) as close to the wall as possible.
NOTE: Be sure there is sufficient extra tubing (about 8 feet [244 cm] coiled into 3 turns of about 10 ″ [25 cm] diameter) to allow the refrigerator to move out from the wall after installation.
Outlet Valve |
|
|
| Ferrule (sleeve) |
|
|
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.
8FLUSH OUT THE TUBING
Turn the main water supply on and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart (1 liter) of water has been flushed through the tubing.
14
