Installation Instructions
9
CONNECT THE TUBING
TO THE REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator, |
be sure the refrigerator power cord is not plugged |
9CONNECT THE TUBING TO THE REFRIGERATOR (CONT.)
Fasten the tubing into the clamp provided to hold it in a vertical position. You may need to pry open the clamp.
into the wall outlet. |
• We recommend installing a water filter if your |
water supply has sand or particles that could clog |
the screen of the refrigerator’s water valve. Install |
it in the water line near the refrigerator. If using |
an approved plastic refrigerator tubing kit, you |
will need an additional tube (WX08X10002) to |
connect the filter. Do not cut plastic tube to |
install filter. |
Remove the access cover.
1/4″ Copper
Tubing
Refrigerator
Connection
Tubing Clamp
1/4″ Compression
Nut
Ferrule
(sleeve)
Approved
Plastic Tubing
Remove the plastic flexible cap from the water valve (refrigerator connection).
Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown. On an approved plastic refrigerator tubing kit, the nuts are already assembled to the tubing.
Insert the end of the tubing into the water valve connection as far as possible. While holding the tubing, tighten the fitting.
For plastic tubing from an approved refrigerator tubing kit, insert the molded end of the tubing into the shutoff valve and tighten compression nut until it is hand tight, then tighten one additional turn with a wrench. Overtightening may cause leaks.
Reattach the access cover.
10TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
15
