AMT Datasouth 5106 Initial Setup, Assembly and Setup Procedure, Selection of Media Output Mode

2.0INITIAL SETUP

2.1Assembly and Setup Procedure

The 5106 printer provides various output modes which will correspond to the various customer requirements. Assemble and setup the printer according to the customer application.

2.2Selection of Media Output Mode

Output Mode under printer parameters provides the selection. Refer to the next section when choosing parameter settings.

Output Mode	Function	Remark
Non-spooled	The label is issued with the liner.	Remove label Presentation
	(The printer does not rewind the	Sensor and then attach the
	label and liner). Attaching the	Tear Bar.
	Tear Bar instead of the
	Presentation Sensor, the label
	and liner can then be torn off
	together (manually)
Spooled		Position the Take-Up
	The label is issued with liner, and	Roller on the outside of the
	the printer rewinds both the	printer (as an external
	issued label and liner on the	rewinder).
	Take-Up Roller (as an external
Presentation	rewinder).
		Set the Take-Up Roller on
	The labels are issued with liner	the inside of the printer.
	and peeled off at the dispenser
	and present Label Holder. The
Optional Cutter	printer rewinds only the liner,
	inside the printer.	Optional cutter mechanism
		is required.
	The labels are issued with liner
	and separated in the specified
	timing by the Optional Cutter.

3