AMT Datasouth 5106 manual ∙ If outside winding label roll is used

6.Place the label roll on the label roll support and push it into the label roll compartment until the roll touches the frame.

∙If outside winding label roll is used:

Place the roll so that it rotates counterclockwise when pulling the leading edge of the liner.

∙If inside winding label roll is used:

Place the roll so that it rotates clockwise when pulling the leading edge of liner.

7.Pull the leading edge of the liner under the white shaft, paper guide and thermal head block.

8.Set the leading edge of the liner in accordance with Media output mode. For example: Wind the liner onto the take-up roller as used in the presentation mode.

9.Place (label) roll holder onto label support. Leave a slight gap between media roll holder and media roll (about 1 mm).

10.Pull the thermal head lever forward to latch the thermal head block. In the “Off-line mode”, press [FEED] a few times in order to remove wrinkles from the ribbon and align label leading edge to thermal head by media gap sensor.

Note:

Make sure to latch thermal head block by thermal head lever. If not, it may result in ‘Head not latched’ error.

If a mechanical adjustment to the thermal head is needed, use the following methods to make adjustments.

If you are using Fan Fold Labels:

∙Load the labels through either position as indicated in Figure 3.

∙Follow the steps you would normally use to load a label roll (over the roll stock and into the paper guide).

7