Step 10

Step 11

Step 12

Step 13 Step 14

CAUTION!

Be sure no interference is present in and around the azimuth axis opening during antenna rotation.

After tensioning both ends of azimuth cable assembly, rotate azimuth to limits of travel (clockwise and counterclockwise) several times to distribute cable tension evenly.

Recheck/verify cable tension at both ends of azimuth cable(s) in accordance with the above recommended procedure. Repeat above cable tensioning procedure if necessary.

If changed earlier, reset the software limits and reconfigure the hardware limits for counter-clockwise azimuth rotation to their previous value/location. Return antenna to stow position before relocating any hard limit actuation blocks (see section titled Azimuth Rotational Limits for more detail).

Verify proper software and hardware limit switch operation.

Replace cable tension access port cover and rear rain shield.

12

Maintenance

Page 12
Image 12
Andrew OM24SNG-RC manual Step