Andrew OM24SNG-RC manual Brake WiresBrake Release Hardware Body Nuts Cover

Step 2

Step 3

Remove the two wingnuts and two nylon washers attaching the brake cover. Refer to Figure 2. Retain removed hardware for later use.

Brake

WiresBrake Release

Hardware

Brake

Body

8-32 Nuts

Brake

Cover

Figure 2

Remove the two 8-32 nuts securing the brake body to the brake base. Once the brake body is removed a large nut attached to the motor shaft and the motor shaft will be revealed. The nut/shaft will be allowed to move freely. If wind or gravity force is present on the antenna the nut/shaft may start to turn. If it turns, the second person should steady the antenna movement until the new brake is installed. Lay aside the brake body, brake cover, and connecting wire until later instructions. Refer to Figure 3. Retain removed hardware for later use.

Brake

Nut

Motor

AzimuthShaft Motor

Brake Cover

8-32

BrakeStud

Body

Figure 3

18 Component Replacement