INSTALLATION REQUIREMENTS (Continued)
CASTER LEVELING INSTRUCTIONS
6.Reinsert each mounting bolt through the caster mounting plate; next, place a spacer of the required size on the bolt before inserting the bolt into the bottom of the fryer.
7.Repeat step 6 for all remaining bolts.
8.Tighten all four bolts with locking nuts evenly and securely against the bottom of the fryer.
(Continued)
9.Return the fryer to its desired location. Lock the front casters to prevent fryer movement and check again for wobbling or rocking. Repeat steps 4 through 8 until no wobbl- ing or rocking occurs. When the fryer no longer wobbles or rocks, perform step 10.
10.Next, perform the “Fryer Restraining
Device Installation Instructions.”
GAS CONNECTION INSTRUCTIONS
Installing your ANETS Fryer requires the fol- lowing procedure, after its legs or casters are pro- perly attached and it is in its desired location.
1.Ensure that the gas safety valve control knob in the fryer has its OFF position next to the valvemark.
2.Ensure that the gas supply inlet line valve is closed (crosswise to the line direction).
3.Ensure that the fryer’s thermostat is set to OFF.
4.Connect the ½”gas supply line to the gas line adapter on the lower rear of the fryer.
! | WARNING |
|
DO NOT use a flame to check for leaks.
5. Turn the gas supply line valve ON; then, check all gas supply line joints and couplings for leaks using soap suds or a
6. Refer to Fryer Operation Recommenda- tions and Fryer Operating Instructions to begin using your ANETS Fryer.
9
