Anetsberger Brothers SLG40 warranty Fryer Troubleshooting Guide, Problem Cause Remedy

FRYER TROUBLESHOOTING GUIDE

All service (repairs or part replacement) must be performed by a qualified Service Agency.

PROBLEM	CAUSE			REMEDY
Pilot flame does not	1. Dirty/sooty pilot burner.		1. Clean the pilot burner. Perform
stay lighted.				the Lighting Procedure.
	2. Low gas supply pressure [less than 6”		2. Measure the gas supply pres-
	W.C. for natural gas (11” W.C. for pro-			sure.
	pane) when all other gas-powered equip-			Contact your local gas supplier
	ment is operating.].			to obtain adequate gas supply
				volume and pressure.
	3. Pilot flame too small to heat thermo pile.		3. Adjust the pilot valve (part of
				the gas safety valve) to in-
				crease the flame size: Un-
				screw and retain the large
				threaded cover; turn the pilot
				valve adjustment screw two
				turns counterclockwise;
				reinstall the threaded cover.
	4. Pilot flame ‘wavering’ (being blown about		4. Block or redirect the draft, to
	by a draft).			keep the flame burning steadily.
	5. Improper thermopile output voltage (must		5. Replace the thermopile.
	be at least 180 millivolts, measured at the
	thermocouple junction block).
	6. High-limit thermostat problem has shut off		6. Check for, and repair, any dam-
	the gas.			aged high-limit thermostat wir-
				ing. Otherwise, test the high-
				limit thermostat by bypassing
				the high-limit thermostat (black
				and blue wires) at the gas con-
				trol valve with a jumper wire.
				Next, perform the Lighting Pro-
				cedure, to check whether the
				pilot flame lights. If the pilot
				flame lights and stays lit, the
				high-limit thermostat has failed
				and must be replaced.
		!		CAUTION: DO NOT return
				the fryer to normal operation
				with its high-limit thermostat
				bypassed.
	7. Gas control valve has failed.		7. Replace the gas control valve.

16