♦The output nozzle becomes very hot during operation (200°C). Keep flammable materials at least 50 cm away from the nozzle.

♦Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it.

Danger of Explosion

♦Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.

♦Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause clogging or “spitting”.

♦Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage to the pump as well as over-heating of the heater.

♦Always drain tank before mailing or transporting this unit.

♦Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water.

Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine

Unpacking & Inspection

Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The shipping carton should contain the following items:

1.One unit of Z-Series II Fog Machine with power cord

2.Mounting brackets with washers/screws (for Z-1200II)

3.Z-8 Multi-function remote control with attached cord (for Z-1200II)

4.Z-20 multi-function remote control with attached cord (for Z-1500II & Z-3000II)

5.User Manual

If any equipment is missing contact your ANTARI dealer immediately.

Before beginning your initial setup on ANTARI Z-1200II, Z-1500II or Z-3000II Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance.

Setup

♦Remove all packing materials from shipping box. Check that all foam and plastic padding is removed, especially in the nozzle area.

♦Place fog machine on a flat surface and remove fog liquid tank cap.

♦Fill with high-quality, water-based fog liquid recommended by ANTARI dealer. Any other types of fluid can damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid tank.

Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.

♦Firmly attach the Z-8 or Z-20 control module cable to the connector inside the rear chamber of the machine.

Z-1200II Operation

♦Add fluid carefully to the liquid tank. Do not overfill the tank.

♦Plug the remote control cord into the slot marked remote control on the back of the machine.

♦Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the machine. The red light on the remote will turn ON once the machine is plugged into a power outlet and the ON/OFF switch is turn ON. The unit will take a couple of minutes to warm up the heater. During this time the machine cannot generate fog. The green light on the remote will turn ON once the machine is ready to produce fog.

♦To emit fog press the green button on the remote. Z-1200II is controlled via the Z-8 remote control.

♦For detailed instruction on the various functions on operating your Z-1200II Fog Machine, see the section titled “Remote Control Operation”.

Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.

3