Z-1500II & Z-3000II Operation

♦Add fluid carefully to the liquid tank. Do not overfill the tank.

♦The Plug should be in a position that is accessible when using the machine.

♦Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the machine. Warm-up is completed when the display on the control module shows “Ready to Fog”

♦To emit fog press the appropriate button on the control module for the desired length of time.

♦The control unit display will display “Warming up” as the machine re-heats to the proper operating temerature.

♦For further information on operating your Z-1500II, Z-3000II Fog Machine, see the section titled “Control Module Operation”.

CAUTION: “Visibility during operation is reduced”.

This model can be operated at a floor level or sitting on any regular surface. Whatever installation method you choose, do not allow the unit to have more than 25 degree angle of inclination.

Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.

Note: If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control connection and power from the wall. If all of the above appears to be O.K., plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Return the machine to your ANTARI dealer.

Technical Specifications

Model

Z-1500II

Z-3000II

Power Supply

AC 100~120V or AC 220~240V, 50/60 Hz

AC 220~240V, 50~60 Hz

Power Consumption

1500 W

3000 W

Output Volume

20,000 cu.ft/min.

40,000 cu.ft/min.

Tank Capacity

6 liters

6 liters

Fluid Consumption

9 mins/ liter (100% output)

5 mins/ liter (100% output)

Weight

14 kgs

19.9 kgs

Dimensions(mm)

L688 W285 H188

L735 W310 H192

Remote Included

Z-20

Z-20

Optional Remote

Z-30PRO

Z-30PRO

Warm-Up Time

8.5 mins

12 mins

Z-20 Control Module Operation:

A 2 meter wired multi-function remote control with 5-pin XLR connector for ANTARI Fog Machine models Z- 1500II and Z-3000II. Its interface allows the operator to customize fog machine functions by adjusting fogging duration, interval and volume. Its LCD displays current operating parameters, which are automatically stored in non-volatile memory, allowing the machine to be powered down without losing function settings. Instructions below:

After switching on, the display shortly indicates »Antari Z-20«. Then the fog machine starts with the warm-up process and the display indicates »Warming Up«. While the unit is warming up, fog output will not be possible yet. Program the necessary menu settings with the control panel. Once the warm-up process is completed, fog output will be possible. The display indicates »Ready to Fog«.

6