Antec SOLO II user manual Washable AIR Filters

4.1

INCLUDED 120 MM TRUEQUIET™ REAR FAN

The SOLO II comes with a 120 mm TrueQuiet™ rear fan. This fan has a two-speed switch that lets you choose the speed best suited to your need. The switch is located at the rear of the case. The default fan speed setting is Low.

120 mm Fan Specifications:
Size:	120 x 25mm two-speed fan
Rated Voltage:	12V DC
Operating Voltage:	10.8V ~ 13.2 V

Speed

High 1000RPM

Low 600RPM

Input Current 0.12A

0.06A

Air Flow 1.0m³ / min (35.8 CFM)

0.6m³ / min (21.5 CFM)

Static Pressure

0.29mm-H2O (0.7inch-H2O)

0.27mm-H2O (0.1inch-H2O)

Noise

19.9dBA

8.9dBA

Input Power 1.44W

0.72W

Note: The minimum voltage to start a typical TrueQuiet™ fan is 7V. We recommend that you set the fan speed to High if you choose to connect the fan(s) to a fan control device or to the Fan-Only connector found on some Antec power supplies. A fan control device regulates the fan speed by varying the voltage, which may start as low as 4.5V to 5V. Connecting a TrueQuiet ™ fan set on Low to a fan-control device may result in the fan not being able to start because the already lowered voltage from the fan control device will be further reduced by the TrueQuiet ™ circuitry below 5V.

4.2

WASHABLE AIR FILTERS

There are two filters located behind the SOLO II’s front bezel.

To clean the filter: Open the front bezel and locate the filter tabs. Push down on the tab and pull the filter away from the case to completely remove it.

24