APC 3500 manual Installation, Overview, Tools, Panel board breakers

Installation

Overview

Warning: Review “Safety” on page 1 before starting this installation. Pay strict attention to all safety warnings and caution notices!

•ALL INTERNAL cable connections were made prior to shipment.

•EXTERNAL cable connections with the UPS need to be made on-site. EXTERNAL cable connections from the utility also need to be made on-site. EXTERNAL cable is not supplied.

•Control wire connections between the UPS and the MBP additionally need to be made on-site. Control wires are not supplied.

•Panel board breakers must be ordered separately. Tie-wraps are not supplied.

Tools

The following tools are required for this installation:

•	Dolly/hand-truck	•	M10 nut driver
•	Tape measure	•	Standard (flathead)
•	Pliers	•	Phillips screwdriver
•	Level	•	T30 Torx screwdriver
•	Marker	•	4mm Allen wrench
•	Drill	• 1/2” socket with ratchet

Panel board breakers

The 42-position panel board supports the following Square D® 1-, 2-, and 3-pole bolt-on circuit breakers. All of the circuit breakers listed below have been pre-tested and approved by APC.

Breaker Type	APC Part#	Breaker Type	APC Part#
1-pole, 20Amp	PD1P20ABBSD	3-pole, 20Amp	PD3P20ABBSD
2-pole, 20Amp	PD2P20ABBSD	3-pole, 80Amp	PD3P80ABBSD
2-pole, 30Amp	PD2P30ABBSD	3-pole, 100Amp	PD3P100ABBSD

Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation 7