Install a wireless network device

You can install a third-party wireless network device by connecting it to the Ethernet port on the appliance using an Ethernet cable. APC currently supports the D-Link DWL-G820, a wireless Ethernet bridge.

To install and configure a third-party wireless network device, see the instructions provided with that device.

The APC Configuration Wizard

Use the Configuration Wizard to configure the following settings on your appliance:

Domain Name Server Settings

Clock and Calendar Settings

Region Settings

Administrator User ID and Password

E-Mail Settings

E-Mail Alert Notification Recipients

The Configuration Wizard downloads the latest available version of BotzWare to your appliance.

When you finish configuring your appliance with the Wizard, your appliance monitors your environment for lack of adequate air flow and for changes in temperature and humidity and detects motion in the area in which the camera is located. Alert conditions detected by any of these sensors generate an e-mail to send to a specified e-mail address.

The Configuration Wizard runs each time you use the Advanced View with your APC appliance until you complete all of the steps in the Wizard or check Don’t Show Configuration Wizard Next Time. You can run the Wizard again by selecting Configuration Wizard from the Advanced View Tools pull-down menu.

NetBotz 455 Installation and Quick Configuration Manual

19

Page 23
Image 23
APC NBWL0456, NBWL0455 configurationmanual APC Configuration Wizard, Install a wireless network device