LCD status indicators
Status | LCD Icon | Audible Alarms | Audible Alarm Terminates |
On Battery |
| Beeps 4 times every 30 seconds. | The beeping stops when AC |
The UPS is supplying battery |
|
| power is restored or the UPS is |
power to the connected |
|
| turned off. |
equipment. |
|
|
|
|
|
|
|
AC Power Overload |
| Constant tone | The alarm stops when |
An overload condition has |
|
| nonessential equipment is |
occurred while the UPS is |
|
| disconnected from the outlets or |
operating on AC power. |
|
| the UPS is turned off |
|
|
|
|
Battery Power Overload |
| Constant tone | The alarm stops when |
An overload condition has |
|
| nonessential equipment is |
occurred while the UPS is |
|
| disconnected from the outlets or |
operating on battery power. |
|
| the UPS is turned off. |
|
|
|
|
Low Battery |
| Continuous beeping | The beeping stops when AC |
The UPS is supplying battery |
|
| power is restored or the UPS is |
power to the connected |
|
| turned off. |
equipment and the battery is near |
|
|
|
a total discharge state. |
|
|
|
|
|
|
|
Battery Fault |
| The UPS will beep twice to indicate | Verify that the battery is securely |
The UPS is operating on AC |
| the battery is disconnected. | connected. |
power. The battery does not |
| The UPS will beep continuously for | The battery is nearing the end of |
provide expected backup. |
| one minute every five hours to | its service life and should be |
|
| indicate that the battery should be | replaced. |
|
| replaced. |
|
|
|
|
|
System Fault | 120 Vac model: | N/A | Identify the fault message on the |
The UPS has experienced an |
|
| display and refer to System |
internal fault. |
|
| Faults in this manual. |
| 230 Vac model: |
|
|
|
|
|
|
6 |
