Power saving LCD screen
The display interface can be configured to remain continuously illuminated or to extinguish after a period of inactivity to save electricity.
1.Continuous Illumination Mode: Press and hold the DISPLAY button for two seconds. The display will illuminate and the UPS will beep to confirm Continuous Illumination mode is activated.
2.Power Saving mode: Press and hold the DISPLAY button for two seconds. The display will extinguish and the UPS will beep to confirm Power Saving mode is enabled. While in Power Saving mode, the display will illuminate when a button is pressed. The display will extinguish after 60 seconds of inactivity.
Sensitivity adjustment settings
The UPS detects and reacts to line voltage distortions by transferring to battery backup power to protect connected equipment. In situations where either the UPS or the connected equipment is too sensitive for the input voltage level it is necessary to adjust the transfer voltage.
1.Connect the UPS to a AC power source. Be sure the UPS is turned off.
2.Press and hold the POWER button for six seconds. The load capacity bar will flash on and off, to indicate the UPS is in Program mode.
3.Press the POWER button again to scroll through the menu options. The UPS will beep to confirm the selection.
When the UPS is in Sensitivity Configuration mode, the Sensitivity bar graph icons display the sensitivity level setting. See the examples here as a reference.
Low sensitivity 1000/1500 VA 120 Vac:
Use this setting with equipment
that is less sensitive to fluctuations in voltage or waveform distortions.
Medium sensitivity 1000/1500 VA 120 Vac:
Use this setting under normal operating conditions.
High sensitivity (Default) 1000/1500 VA 120 Vac:
Use this setting when connected equipment is sensitive to any minor fluctuations in voltage or waveform distortions.
4 |
