Program Switches
|
| OFF | ON |
1 | TIMER TO CLOSE | Gate does not automatically close. | Gate automatically closes. |
2 | TIMER TO CLOSE OPT. | Gate automatically closes from | Gate automatically closes only when completely |
|
| any position after opening. | open (open limit engaged). |
3 | SLAVE DISABLE | Enables slave side (dual gate use). | Disables slave side. (single gate use) |
4 | SIREN DELAY | Siren (optional) active when gate is | Siren (optional) starts 5 seconds before gate moves. |
|
| moving. |
|
5 | ‘STOP’ CIRCUIT ENABLE | Must hold down open or close | Normal operation |
|
| buttons to move gate. Gate stops | Momentary open or close input runs gate to limit. |
|
| when button released. |
|
6 | LOCK TYPE | For 12V mechanical (solenoid) locks. | For 12V magnetic locks. |
|
| (+12V for 4 seconds on open cycle) | (+12V when on close limit) |
7 | COAST ENABLE | Gate will stop immediately when at | Gate will coast (minimally) when it reaches limits. |
|
| Open or Close limit | Recommended for 7500 slide operator only. |
8 | FREE EXIT OPT. | A free exit input will open gate from | A free exit input will open gate from any |
|
| closed position or after a close cycle | position after an open or close cycle. |
|
| only. |
|
9 DUAL GATE SYNC | Both gates operate at normal |
| Speed (slave slower than |
| Master). |
This feature will control the master gate to open or close at the same speed as the slave gate.
10 SMART ACT. | Off for 416E & 416EX actuators, | Used for 816E & 816EX actuators only |
| slide gates, 3500 or when slow down | (soft start & stop). |
| feature is not desired. |
|
| 16 |
|
