iMac G5 (20-inch iSight) Take Apart —Stand 136
Replacing the Stand
Make sure the stand is erect and the end of the stand is inserted through the mounting hole 1.
in the rear housing.
Position the clutch on the stand, with the clutch springs at bottom. Install the seven long, 2.
clutch-to-stand mounting screws.
Adjust the clutch so that its chassis mounting holes align, and install the four screws that 3.
secure the clutch to the chassis.
Replace the silky EMI tape on top of the mechanism, press it into place.4.
Replace the metal mechanism cover.5.
Replace the EMI tape along the top and bottom of the mechanism cover. Make sure the 6.
spring clip on the right side of the mechanism cover is attached to the mechanism cover.
Replace the CPU fan. 7.
Replace the logic board.8.
Replace the speakers.9.
Replace the display panel.10.
Replace the IR Board.11.
Replace the lower EMI shield.12.
Replace the front bezel.13 .
Replace the memory access door.14.