12.Slide the logic board back in.
Push on the edge of the logic board until it is finally in place.
13.If there is a connector on the card that you just installed (for example, if you are installing an Apple IIe Card), remove the access cover on the back panel you removed earlier.
Pinch together the plastic tabs on the access cover to remove it and pop it out. With the access cover off, you can use the port on the card you just installed.
14.Replace the back panel of the computer.
Slip the back cover over the prongs at the bottom edge of the back of the computer. If your back panel was held on by screws, replace them.
sWarning: Never turn on your computer unless all of its internal and external parts are in place. Operating the computer when it is open or missing parts can be dangerous, and can damage your computer. s
28
