2.10 | INSTALLATION |
Insert the tip of a small screwdriver (or thin flat blade like a butter knife) between the outside case and the back panel at point A identified in Figure 2.3. Pry out the back panel until the tab pops free of the notch in the Hr case. Continue the same procedure working up and across until the tab on the side and the one tab on the top right side are free.
You may be able to pull the right side of the panel away from the case at this point as Figure 2.4 shows. If you can, you say be able to free the middle tabs by pulling up on the top of the case with one hand while prying the panel Out with the other hand.
If the top of the //c does our yield, you may need to continuing prying the back panel away from the //c 4th the screwdriver at the remaining tab points. Working from left to right, continue prying until all the top tabs are free.
With the top tabs pulled out of the //c case, pull the back panel away from the case as Figure 2.5 shows. The remaining tab at the left aide of the panel should pop loose. Set the back panel aside.
4.Remove the top cover of the Nc as Figure 2.6 shows. Grasp the top cover at both rear corners and push upward. Push upward until the case has moved up a few inches and then pull back and up on the cover. When you pull the case back, the top cover should be freed from one plastic hook in the middle of the front of the case.
Put the top cover safely aside.