Technical Specifications
* Specifications are subject to change without notice.
Compatible Cards CompactFlash cards: 2MB (5V), 4MB (3.3/5V), 8MB (3.3v), 16MB (3.3V), 32MB, 48MB+
Host Interface | USB port (Universal Serial Bus) |
Connector of Accessory Cable | Host side USBport (Universal Serial Bus) |
Transfer Rate | Up to 800~900KB/s sustained transfer in read mode |
| Up to 470KB/s sustained in write mode |
Power Consumption | 1.25 watts typical (255mA@5v) no media activity |
Dimensions | 65 mm (Wide) x 100 mm (Deep) x 18 mm (High) |
USB cable | 1 metre+ / - 10% shielded twisted pair for signal |
| wires. Input impedence 90 Ohms + / - |
Weight (Main unit) | Approximately 101 g |
Operational Environment | |
| Humidity during use: 5% to 96% |
| (without condensation) |
Federal Communications Commission
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions,may caurce harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n Connect the equipment into an outlet on a circuit different from that to witch the receiver is connected.
n Consult the dealer or an experienced radio/TV technician for help Shielded interface cables must be used in order to comply with emission limits.
Specfications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
18
