Setup & Testing
Ventilation System Settings Table (continued)
|
| Factory default setting (bold) |
System setting | Description | and setting range |
|
|
|
Number of Bedrooms | Selects the number of bedrooms to be used for the ASHRAE | 3 Bedrooms |
| calculation.. (Only available if fresh air setup is set to ASHRAE..) | 1 to 6 Bedrooms |
Number of Occupants | Selects the number of occupants to be used for the ASHRAE | 4 Occupants |
| calculation.. (Only available if fresh air setup is set to ASHRAE..) | 1 to 10 Occupants |
Home Size | Selects the home size to be used for the ASHRAE calculation.. | 2500 SQ FT |
| (Only available if fresh air setup is set to ASHRAE..) | 1000 to 5000 SQ FT |
Fresh Air CFM | Selects the ventilation CFM to be used for the ASHRAE | 60 CFM |
| calculation.. (Only available if fresh air setup is set to ASHRAE..) | 30 to 200 CFM |
Select Climate | Selects the climate to be used for the ASHRAE calculation.. | Normal |
| (Only available if fresh air setup is set to ASHRAE..) To | Very Hot/Humid |
| determine what region you are in, refer to the map below. | Very Cold |
ASHRAE Cycle Time | Displays the Fresh Air Time calculated by the ASHRAE | Minutes/Hour |
| standard.. (Only displayed if fresh air setup is set to ASHRAE..) |
|
Note: In ASHRAE
Note: Refer to manuals for humidifier, dehumidifier, air cleaner and ventilation products for recommended installation and operation..
CLIMATE MAP FOR ASHRAE FRESH AIR SETUP
Setup & Testing
Removal of Indoor Air Quality Control Buttons
If any of the Indoor Air Quality control features are not installed, the corresponding button can be removed using the following procedure:
Step 1: Verify the specific Indoor Air |
| |
Quality control feature is not |
| |
installed in the installer | Indoor | |
(see pages | ||
Air Quality | ||
Step 2: From the home screen (see | CONTROL | |
Buttons | ||
page 17), press and hold the | ||
| ||
IAQ button for 7 seconds.. |
| |
Step 3: The message center will |
| |
display REMOVE BUTTON and |
| |
the options of NO and YES |
| |
(NO will be flashing). |
|
Step 4: Press or to select YES..
Step 5: Press [DONE]..
Step 6: The button is now removed..
Note: Once the button is removed it can be brought back by installing the corresponding Indoor Air Quality feature (see pages
System test menu
The system test menu is used to test a system after installation.. The outputs of the thermostat can be manually activated to test their function.. The instructions below show how to enter the test mode and turn outputs on and off..
VERY COLD |
How to enter the system test menu:
Press [MODE] to set system to off..
Press and hold [FAN] and [MODE] for three seconds to enter system test mode..
The first screen of the installer test displays the equipment configuration..
Press [NEXT] to enter the first installation test or [CANCEL] to exit.
SYSTEM TEST STEPS
Heating equipment test
Cooling equipment test
Fan equipment test
Humidification equipment test Dehumidification equipment test Ventilation equipment test
VERY HOT/HUMID |
Temperature
Humidity |
Outdoor |
Temperature |
Equipment |
Configuration |
12 | 13 |