7. PREVENTATIVE MAINTENANCE SCHEDULE
Tools required: Daily: Heat Resistant Gloves, Standard Cleaner, Standard Sanitizer, Soft Towels. Monthly: Needle Nose Pliers, Soft Brush
Yearly: Phillips Screwdriver, Standard Lubricating Oil
1)Preventative Maintenance - Daily
WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt.
A.Exterior. Everyday you should clean the outside of the toaster by wiping it down with a soft cloth and detergent.
B.Cooling Fan. Check air intake. The cooling fan grille on the side of the toaster must be cleaned daily clean grille with a stiff nylon type brush. The cooling fan operates when the power switch is turned to on. It must operate to keep the electrical control compartment below 140°F (60°C).
WARNING! If the fan blade is not rotating, or fan assembly is missing from main blower motor shaft, do not operate toaster. Serious damage could be done to the blower motor and / or the
C.Additional cleaning according to the instructions described on page 7 & 8.
D.Remove the top cover and bun chute and clean in a sink.
E.Remove the release sheet and wipe clean with a damp cloth. Be careful not to crinkle it or rip it at the crease. Be careful when removing it since it might still be hot.
2)Preventative Maintenance - Weekly
WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the release sheet,
and cleaning the silicone belt.
|
|
|
| Cleaning Silicone Belt |
A. | Clean Silicon Belts. In | addition to the daily cleaning |
| |
| described above, remove the top cover. Open one side |
| ||
| (front or rear) of the toaster and clean the orange silicone |
| ||
| belt. Using a standard cleaner, wipe across and down. |
| ||
| Clean both sides of each silicone belt. To rotate the belt, |
| ||
| depress the safety interlock switch located on the top of the |
| ||
| toaster. |
| 12 |
|
|
|
|
| |
| WARNING! Do not allow articles of clothing, hands, |
| ||
| fingers, or any foreign objects from being caught in the |
| ||
|
| |||
| rotating conveyor belt. To stop the conveyor from turning, |
| ||
| release the safety interlock switch. |
|
| |
|
|
| ||
| Follow cleaning by wiping down both sides of each silicone | Cleaning Release Sheets | ||
| belt with a standard sanitizer. Turn the toaster on the |
| ||
| counter to access the other silicone belt, and repeat the |
| ||
| cleaning instructions. |
|
|
|
B. | Clean Release Sheets. | Carefully remove the Release |
| |
| Sheet, laying it flat on a clean surface. Using a standard |
| ||
| cleaner, wipe down both sides of the sheet until clean. |
| ||
| Follow cleaning by wiping down both sides of the sheet |
| ||
| with a standard sanitizer. If the Release Sheet appears to |
| ||
| be overly worn, replace it. |
|
|
|
|
|
|
| |
