Release Sheet Replacement
1 | 2 | 3 | 4/5 |
6 | 7 | 8 | 9/10 |
1.Turn toaster off.
2.Remove the top cover.
3.Remove old release sheet from the toaster platen (grill).!!! CAUTION !!! TOASTER PLATEN MAY BE HOT.
4.If the reverse side of the release sheet is still good, then fold the release sheet the opposite way and use the other side. Skip to step 6.
5.If using a new release sheet, fold the release sheet in half
6.Turn toaster on. (Conveyors will not run because top cover is removed.)
7.Move the conveyors out full. (The bun thickness dials point straight up.)
8.Drape the release sheet over the toaster platen and go about 5” down.
9.While holding the release sheet with one hand, press the conveyor button on top to start the conveyors. As the conveyors turn, they will help the release sheet to go down. !!!
CAUTION !!! BUTTON MAY BE HOT.
10.When the crease reaches the top of the platen, release the conveyor button.
Release Sheet Kit |
|
|
11 | 12 | 13 |
6. TROUBLESHOOTING GUIDE
Always ask and check the following: |
| |
1. | Is the unit connected to a live power source of the proper voltage? | |
2. | Check the circuit breaker. |
|
3. | Is power switch “ON” and pilot light glowing? |
|
4. | Check the rating label. Is the unit connected to the correct power | |
| source? | 9 |
Service Hotline (800)
11. | R e p l a c e | t h e | t o p | ||
| cover to the | toaster. | |||
| (Conveyor | starts | to | ||
| move.) |
|
|
|
|
12. | Let the | toaster | run | ||
| f o r a b o u t | 3 0 | |||
| minutes | to | warm | up | |
| the release sheet. |
| |||
13. | R e - a d j u s t | t h e | |||
| conveyors to their | ||||
| p r o p e r s e t t i n g s | ||||
| u s i n g t h e b u n | ||||
| thickness dials. |
|
|
Removing Release Sheet