Reference
Before you start |
|
WARNING: Do not make any connections to your amplifier while it is switched on or connected to the mains supply.
Before switching on please check all connections thoroughly, making sure bare wires or cables are not touching the amplifier in the wrong places (which could cause short circuits) and you have connected positive (+) to positive and negative
Always ensure that the volume control on your amplifier is set to minimum before starting these procedures.
Bi-wiring your loudspeakers
The performance of your system can be further enhanced over that achieved with
Connect the AVR200 to the high frequency (HF) terminals and connect your power amplifier to the low frequency (LF) terminals.
You will need:
Speakers – with four input terminals each (as with
Two amplifiers – one of these would be the AVR200 and the other an Arcam power amplifier (e.g. an P75 or P85).
Loudspeaker cables – one pair of cables per loudspeaker or a suitably terminated cable set (a loom, probably prepared by your dealer and capable of being used for
Interconnect cables – one pair of high quality interconnect cables.
You will need:
Speakers – with four input terminals each: these will be marked HF (High Frequency) and LF (Low Frequency).
Loudspeaker cables – two pairs of cables per loudspeaker (which may be joined at the amplifier end if your amplifier has only one pair of output terminals per channel). Or, a suitably terminated cable set (a loom, probably prepared by your dealer and capable of being used for
How to bi-wire loudspeakers
1.Remove the terminal links on the rear of your loudspeakers
WARNING: This step is essential or damage to your amplifier may result which is not covered under warranty.
2.Connect the cables as shown in the diagram below, ensuring correct polarity at all times.
|
| R | Arcam AVR200 receiver | L | ||
|
|
|
|
| ||
|
| + |
|
|
| + |
|
| – |
|
|
| – |
+ | HF | – Right |
| + | HF | – Left |
+ | LF | – speaker | + | LF | – speaker |
How to set up a bi-amped system
1.Remove the terminal links on the rear of your loudspeakers.
WARNING: This step is essential or damage to your amplifier may result which is not covered under warranty.
2.Connect the cables as shown in the diagram below, ensuring correct polarity at all times.
3.Use the interconnect cables to connect the AUDIO PRE- OUT sockets of the AVR200 to the corresponding PWR AMP IN sockets of the power amplifier.
| R | Arcam AVR200 receiver | L |
|
| + | + | ||
|
|
| ||
– |
|
| – |
|
+ |
| – | + | – |
Right | HF |
| HF | Left |
speaker | LF | – | LF | speaker |
|
| |||
+ |
| – | + | – |
+ |
| – | + | – |
| R |
| L |
|
|
| Arcam AP85 power amplifier |
|
|
| Recommended |
AVR200
16