FM Mute/Mono
The AVR250’s tuner has an
Should you wish to listen to a station that is ‘auto muted’ press the FM MUTE/MONO button again to disengage the muting circuit. The tuner now switches to monoaural reception, cancelling much of the background hiss. ‘FM MUTE’ is no longer displayed and you are able to continue listening.
Listening to the tuner in Zone 2
The tuner can be selected, as other inputs, for routing to Zone 2. Note, though, that it is not possible to listen to different stations in the main zone and Zone 2 simultaneously. This is because the AVR250 is fitted with just a single tuner module.
Using the Main Menu
Three ‘Main Menu’ screens allow
The three Main Menu screens are available on your display device. The selected line of each screen is also displayed on the front panel of the AVR250. Each of the following sections has a picture showing the screen that is displayed as you move through the menus.
Using the remote control to enter the Main Menu
Briefly press the MENU button to enter ‘Main Menu Screen 1’. Use the navigation5and6buttons to go up and down the menu respectively. The3and4buttons are used to alter the selection on the highlighted line, or to change to the next screen if the menu heading is highlighted.
Using the front panel to enter the Main Menu
Press the MENU button to enter the main menu. To cycle through the items on a menu, use the
EFFECT /6 button to go down and MODE/5button to go up one line for each press. Use the volume control knob for the3and4functions in order to cycle through the available choices, or to change the menu page if the menu heading is highlighted.
Main Menu Screen 1
Vol: Shows the present volume being used for the main zone and can be adjusted from here.
Audio Input: This shows the current audio input source selected. The current audio input can be changed when this line is highlighted using the source select buttons on the front panel or the remote. Note that changing the audio input also changes the video input to the same setting.
Video Input: This shows the current video input source selected. The current video input can be changed when this line is highlighted using the source select buttons on the front panel or the remote.
Changing the video input does not change the audio input, so you can watch a different input from the one you are listening to.
If the audio and video are set to different inputs, they will be reset to be the same input when the audio input is next changed.
Note: the
Video Type: This setting is applicable only to TVs being fed via a SCART lead where the trigger outputs fl and fm are connected via suitable SCART header. It shows the video aspect ratio currently selected for the display, which can be set manually to 4:3 or 16:9, depending on which format you are feeding into your TV. See page 12 for further details on using these triggers.
Stereo Direct:
nOFF: the AVR250 functions in its normal way.
nON: the AVR250 uses the analogue input signal for the source, bypassing the digital circuitry. In
this mode, the AVR250 functions like an analogue amplifier: it also shuts down all the unused digital circuitry for optimum stereo performance. Note that no digital output is available in this case.
Bass and Treble: These allow you to alter temporarily the bass and treble controls for all currently active speakers. In the case of Stereo, this would only apply to the front left and right speakers. In Effects, Pro Logic IIx Music, Dolby Digital and DTS modes (for example), this would apply to all present speakers.
You can adjust the bass and treble by up to ±6dB. These adjustments are in addition to those made in ‘Speaker Eq’ in the
Note that bass and treble alterations are not available in Stereo mode when AUTO STEREO TONE BYPASS is set to YES, or in Stereo Direct mode.
Balance: To alter temporarily the sound balance between the front left and right speakers. You can alter the sound stage to either the left or right by up to 10dB. Note that it is not possible to shift the audio signal completely over to one channel.
English
AVR250
