Arcam AVR400 Component/RGB video connectors, Zone 2 connectors, Digital audio connectors, E-11

Component/RGB video connectors

Zone 2 connectors

The Z2 out analogue audio connector can be used to connect the stereo audio output of the AVR400 to an amplifier located in a second room. Connect the analogue video output to your Zone 2 display equipment. See ‘Multi-room Setup’ on E-46 for information.

Digital audio connectors

English

These inputs are suitable for connection to source devices which output Component (YUV or YPbPr) or RGB high quality analogue video signals. These signals are usually available from BD players, set-top boxes or games consoles.

If you are connecting up to an RGB source you may also need to connect the source’s Composite output to the AVR400 Composite input to act as a video sync (‘RGB

+Sync’ format). The Composite signal should be on the same named input as the RGB signals. The AVR400 is also compatible with ‘Sync on Green’ or ‘RGsB’ signals.

RGB video outputs on source equipment are often on SCART connectors. You will need to use a SCART to ‘RGB+Sync on phono’ breakout cable, available from your Arcam dealer.

NOTE

When setting up the AVR400 menus (later in this manual), you will need to select whether the three-wire high quality video input is Component (‘Normal’), ‘RGsB’ or ‘RGB + Sync’ for each input. This is done on the ‘Component Mode’ line in the Input Config menu. Failure to do this can result in a green looking picture or a picture that is unstable.

COMPONENT VIDEO IN SAT, AV, BD

Connect the Component video outputs of your source equipment to these inputs.

COMPONENT VIDEO OUT

Connect this output to the Component video input of your display device.

NOTE

Analogue RGB video output is not available from the AVR400. The analogue three-wire high quality video output is always configured as Component video.

S-Video and Composite connectors

AV, VCR, BD, SAT

Connect these inputs to the S-Video and Composite outputs of your available source equipment.

VCR, PVR, BD, CD, AV, SAT

Connect these inputs to the digital outputs of your available source equipment.

E-11