7. Remote 12V Trigger Outputs

Two trigger outputs are provided. The output labeled “ON/OFF” provides a 12V voltage level whenever the unit is fully powered up. When the unit goes into standby, the level is 0 Volts.

The output labeled “AUX” is programmable from the LCD menu as described below. This means that the termi- nal supplies the 12-Volt signal only when you switch to certain, specified inputs.

The Centre (Common or Ground) terminal is always used with the “ON/OFF” or “AUX” terminals to complete the circuit loop. The 12-Volt connector will accept 1/4 - inch stripped wire ends, inserted into the square holes provided, and the adjacent screws carefully tightened to hold them in place.

These can be used to control any Bryston Power amplifier and many other components such as motorized screens and drapes. Be sure to determine what type of trigger signal the selected components requires and what function will be enabled by the trigger signal’s voltage.

Programming the AUX Trigger Output

i.Enter the main menu by pressing on one of the menu buttons on the SP1 front panel. Move the cursor to “OS”. Hit ‘Select’ - You are now in the Other Settings (Optical/THX) Menu.

ii.Move the cursor to “T”. (T = Trigger) Hit ‘Select’. Now you can assign the AUX Trigger output to ON or OFF, for each of the 6 input sources.

Figure 9: Trigger Assign Menu

iii.To change the source, use the “<” button. To toggle the trigger setting On or Off, use the “>” button. Hit ‘Select’ to exit when finished.

8. Aux IR Receiver

The Aux IR Input is a miniature mono phone jack connector. This is used to connect externally mounted IR LED receivers, or other extenders that provide modulated IR receiver data. Data is retransmitted by an IR LED mounted near the front panel IR receiver.

9. RS-232 connector

This connection provides for control of a Bryston SPV-1 video switcher, or remote control of the SP1.7 functions via a computer interface or AMX/Crestron type controller. Please contact your dealer or Bryston to make use of this optional feature and determine which devices are compatible.

14

Page 16
Image 16
Bryston SP1.7 manual Remote 12V Trigger Outputs, Programming the AUX Trigger Output, Aux IR Receiver, RS-232 connector