Manuals / Bryston / Home Audio / Stereo Amplifier

Bryston SP1.7 manual Status LED, Photo Sensor

Models: SP1.7

1 40
Download 40 pages 18.8 Kb
Page 19
Image 19
12. Status LED

Pressing the OSD (On-Screen Display) Button will toggle the OSD function on and off, on your video monitor, if you are using the Bryston SPV-1 video switcher.

Pressing the SUB button will engage the menu for the volume trim level of the subwoofer channel. Use the MENU/UP/DOWN button to change the subwoofer channel level up or down. Press SELECT when finished.

Pressing the CENTER button will engage the menu for the volume trim level of the center channel. Use the MENU/UP/DOWN button to change the center channel level up or down. Press SELECT when finished.

Pressing the REAR button will engage the menu for the volume trim level of the rear channels. Use the MENU/UP/DOWN button to change the rear channel levels up or down. Press SELECT when finished.

Pressing the BACK button will engage the menu for the volume trim level of the back channel(s). Use the MENU/UP/DOWN button to change the back channel level(s) up or down. Press SELECT when finished.

12. Status LED

Indicates remote control status while accessing discrete/hidden functions, and changing remote options. Contact the factory for details.

13. Photo Sensor

Works in conjunction with the backlight and tilt switch to determine if backlighting is needed.

NOTE: To enable or disable the backlight in the remote control, follow this procedure:

i.Press CODE button for 5 seconds

ii.LED will flash red, then release button

iii.Type in 3 digit code 792 = MODE / SAVE / DTS

iv.LED will flash again to confirm

To send discrete/hidden Code…

i.Press CODE button and release

ii.LED will illuminate (Red)

iii.Type in 3 digit code (a combination of mode buttons)

iv.LED will flash again to confirm and go out.

For a list of hidden codes, visit the Bryston Website at www.bryston.ca

17

Page 18 Page 20
Page 19
Image 19
Bryston SP1.7 manual Status LED, Photo Sensor
Page 18 Page 20

FAQ

How do I toggle the OSD function on and off?

Press the OSD On-Screen Display Button to toggle the OSD function on and off on your video monitor, if using the Bryston SPV-1 video switcher.

How do I change the volume trim level for the subwoofer channel?

Press the SUB button to engage the menu for the volume trim level of the subwoofer channel. Use the MENU/UP/DOWN buttons to adjust the subwoofer channel level and press SELECT when finished.

How can I enable or disable the backlight in the remote control?

To enable or disable the backlight in the remote control, press the CODE button for 5 seconds, then follow the specific procedure outlined in the article. Visit the Bryston Website for a list of hidden codes.